Synonyms: None
CAS No.: 142-31-4
Molecular Weight: 232.27
Chemical Formula: CH3(CH2)7OSO3Na
Product Codes: V063
Ingredient CAS No Percent Hazardous --------------------------------------- ------------ ------------ --------- Sodium Octyl Sulfate 142-31-4 94 - 100% Yes
Emergency Overview
--------------------------
WARNING! CAUSES EYE AND SKIN IRRITATION. POWDERED MATERIAL MAY FORM EXPLOSIVE DUST-AIR MIXTURES. CAUSES EYE AND SKIN IRRITATION.
Potential Health Effects
----------------------------------
Inhalation:
None identified.
Ingestion:
Irritation.
Skin Contact:
Irritation.
Eye Contact:
Irritation, may cause burns.
Chronic Exposure:
No information found.
Aggravation of Pre-existing Conditions:
Damaged skin.
Inhalation:
If inhaled, remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Prompt action is essential.
Ingestion:
If swallowed, DO NOT INDUCE VOMITING. Give large quantities of water. Never give anything by mouth to an unconscious person. Get medical attention immediately.
Skin Contact:
In case of contact, immediately flush skin with plenty of water for at least 15 minutes.
Eye Contact:
In case of eye contact, immediately flush with plenty of water for at least 15 minutes.
Fire:
Not expected to be a fire hazard.
Explosion:
Fire or excessive heat may produce hazardous decomposition products. This product, which is organic in nature, has the potential to cause a dust explosion.
Fire Extinguishing Media:
Water spray; Dry chemical; Carbon dioxide.
Special Information:
Wear self-contained breathing apparatus and protective clothing to prevent contact with skin and eyes.
Sweep up material and package for safe feed to an incinerator.
Keep from contact with oxidizing materials. Containers of this material may be hazardous when empty since they retain product residues (dust, solids); observe all warnings and precautions listed for the product.
Airborne Exposure Limits:
None established.
Ventilation System:
A system of local and/or general exhaust is recommended to keep employee exposures as low as possible. Local exhaust ventilation is generally preferred because it can control the emissions of the contaminant at its source, preventing dispersion of it into the general work area. Please refer to the ACGIH document, Industrial Ventilation, A Manual of Recommended Practices, most recent edition, for details.
Personal Respirators (NIOSH Approved):
For conditions of use where exposure to the dust or mist is apparent, a half-face dust/mist respirator may be worn. For emergencies or instances where the exposure levels are not known, use a full-face positive-pressure, air-supplied respirator. WARNING: Air-purifying respirators do not protect workers in oxygen-deficient atmospheres.
Skin Protection:
Wear impervious protective clothing, including boots, gloves, lab coat, apron or coveralls, as appropriate, to prevent skin contact.
Eye Protection:
Use chemical safety goggles and/or full face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.
Other Control Measures:
There is insufficient data in the published literature to assign complete numerical SAF-T-DATA* ratings and laboratory protective equipment for this product. Special precautions must be used in storage, use and handling. Protective equipment for laboratory bench use should be chosen using professional judgment based on the size and type of reaction or test to be conducted and the available ventilation, with overriding consideration to minimize contact with the chemical.
Appearance:
White Crystalline solid.
Odor:
Odorless.
Solubility:
Appreciable (> 10%)
Specific Gravity:
No information found.
pH:
No information found.
% Volatiles by volume @ 21C (70F):
0
Boiling Point:
No information found.
Melting Point:
No information found.
Vapor Density (Air=1):
Not applicable.
Vapor Pressure (mm Hg):
0 @ 20C (68F)
Evaporation Rate (BuAc=1):
0
Stability:
Stable under ordinary conditions of use and storage.
Hazardous Decomposition Products:
Carbon dioxide, carbon monoxide, oxides of sulfur.
Hazardous Polymerization:
Will not occur.
Incompatibilities:
Strong oxidizing agents.
Conditions to Avoid:
No information found.
--------\Cancer Lists\------------------------------------------------------
---NTP Carcinogen---
Ingredient Known Anticipated IARC Category
------------------------------------ ----- ----------- -------------
Sodium Octyl Sulfate (142-31-4) No No None
Environmental Fate:
No information found.
Environmental Toxicity:
No information found.
Whatever cannot be saved for recovery or recycling should be managed in an appropriate and approved waste disposal facility. Processing, use or contamination of this product may change the waste management options. State and local disposal regulations may differ from federal disposal regulations. Dispose of container and unused contents in accordance with federal, state and local requirements.
Not regulated.
--------\Chemical Inventory Status - Part 1\---------------------------------
Ingredient TSCA EC Japan Australia
----------------------------------------------- ---- --- ----- ---------
Sodium Octyl Sulfate (142-31-4) Yes Yes Yes Yes
--------\Chemical Inventory Status - Part 2\---------------------------------
--Canada--
Ingredient Korea DSL NDSL Phil.
----------------------------------------------- ----- --- ---- -----
Sodium Octyl Sulfate (142-31-4) Yes Yes No Yes
--------\Federal, State & International Regulations - Part 1\----------------
-SARA 302- ------SARA 313------
Ingredient RQ TPQ List Chemical Catg.
----------------------------------------- --- ----- ---- --------------
Sodium Octyl Sulfate (142-31-4) No No No No
--------\Federal, State & International Regulations - Part 2\----------------
-RCRA- -TSCA-
Ingredient CERCLA 261.33 8(d)
----------------------------------------- ------ ------ ------
Sodium Octyl Sulfate (142-31-4) No No No
Chemical Weapons Convention: No TSCA 12(b): No CDTA: No
SARA 311/312: Acute: Yes Chronic: Yes Fire: No Pressure: No
Reactivity: No (Pure / Solid)
Australian Hazchem Code: None allocated.
Poison Schedule: None allocated.
WHMIS:
This MSDS has been prepared according to the hazard criteria of the Controlled Products Regulations (CPR) and the MSDS contains all of the information required by the CPR.
Label Hazard Warning:
WARNING! CAUSES EYE AND SKIN IRRITATION. POWDERED MATERIAL MAY FORM EXPLOSIVE DUST-AIR MIXTURES. CAUSES EYE AND SKIN IRRITATION.
Label Precautions:
No SAF-T-DATA Ratings have been developed for this product. Read and follow all warnings, precautions, instructions and other safety and handling information on the label and MSDS.
Avoid contact with eyes, skin, clothing.
Use with adequate ventilation. Wash thoroughly after handling.
Label First Aid:
In case of contact, immediately flush eyes or skin with plenty of water for at least 15 minutes. Remove contaminated clothing and shoes. Wash clothing before reuse.
Product Use:
Laboratory Reagent.
Revision Information:
New 16 section MSDS format, all sections have been revised.
************************************************************************************************
Prepared by: Environmental Health & Safety
Phone Number: (314) 654-1600 (U.S.A.)